100-inch Thorn Assembly

Previous Home Next

1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12 | 13 | 14 | 15 | 16 | 17 | 18 | 19 | 20 | 21 | 22 | 23 | 24 | 25 | 26 | 27

c-joinerinstall

I left the two brass joiner tubes in one piece and epoxied them in with cabasil-thickened epoxy. Because the dihedral is so small that the top surface of the wing is flat, I only needed to clamp the leading edge and trailing edge as shown to assure a straight fit. Two steel blocks on wax paper weigh down the contraption while the epoxy cures.